A few of the full scale hand held props are shown here.

A graphic is placed in the disk frame. The assemblies are attached to a piece of textured styrene completing the middle panel assembly.

The middle panel assembly is attached to the aluminum side panels. A piece of aluminum L shape is cut to size and attached. Small strips of aluminum are cut to size and attached to the two door panels.

The lower door is attached. A non-functional hard drive was dismantled and it's inner workings pulled out. These printed circuit boards are placed into the lower section.

The top hood and middle door are attached.

A vinyl strap is cut to length and attached to the side panels. The side panels were then epoxied to the main body, completing assembly. 1 2

Main Page / Modeling Links

Contact us: info@ThomasModels.com